• <dd id="y4tlf"></dd>

    <th id="y4tlf"></th>
    <tbody id="y4tlf"><pre id="y4tlf"></pre></tbody>

    Technology Center
    當前位置:網站首頁 > 技術中心 > 技術詳情
    2017-06-16 16:28










    Shed boards are kept upright during transportation and storage, and are not allowed to be stacked. In any case, the shed should be kept dry.

    After sintering, the white paint sprayed on the surface of our factory can be used normally for 3-6 months. If the white paint on the surface needs to be replaced, we can use the paint prepared by our factory to remove the old paint as much as possible before spraying. Then spray gun construction, the thickness is suitable for 0.4-0.6mm.

    After spraying the construction of the shed board, it can be used only after it is completely dry.

    The green body is placed on the shed. Special attention should be paid to the complete drying of the green body. The bottom of the product contacts the shed, so wipe the glaze clean to avoid sticking to the porcelain.

    When the trolley is loaded, the refractory column should be kept in a straight line, so as not to affect the life of the slab due to different support points.

    When the trolley is loaded, the distance between the slab and the slab is determined by the height of the blank, and the appropriate gap is 10-20mm. The appropriate gap between the blank and the blank should also be retained. Make the flame and air convection burning in the kiln smoother.

    Avoid rapid cooling and rapid heating when the shed board is in normal use to avoid cracking of the shed board, so special attention should be paid to the setting of firing time and temperature.

    If you have any questions during use, please contact us or the supplier in time. Our good after-sales service will make you satisfied.

    產品推薦 Product recommend